Description
PQ215, PCB Holding and Probe Positioning System, Kit 1
You have only two hands, but you need to hold the PCB and up to 4 scope probes for your measurements?Here is the solution! If you already own a PicoScope 6000E which is supplied with four probes, the Kit 1 is the ideal add-on.
The Pico oscilloscope probe positioning system holds your circuit board firmly during soldering, inspection and test. For testing, the kits are supplied with probe holders which secure magnetically to the steel base plate. For the scope probes there are holders with magnetic feet and flexible gooseneck available. When the probes are installed in the holders they can be positioned to make contact with points of interest on the circuit board and will remain in contact while you make measurements in the PicoScope software. The large steel base plate is mirror finished allowing you to see any items such as status LEDs underneath the PCB.
Kit contents:
4 x magnetic PCB holders
1 x steel base plate, 210 x 297mm²
1 x set of insulation washers for the PCB holders
4 x Pico probe holders, 2.5mm
1 x set of cable holders, channels A-D
1 x set of cable holders, channels E-H