Automotive Breakout Lead for ACS Sensors, 2-Pin
Automotive Breakout Lead for ACS Sensors, 2-Pin
The TA190 ACS breakout lead enables voltage readings to be taken from the numerous 2-pin sensors and actuators in the engine compartment. The breakout lead is simply connected into the existing cable loom, and the output signal can then be taken from the two 4 mm banana plugs into the automotive oscilloscope using TA000 BNC to 4 mm test lead (or TA125 to TA128 premium test leads). The breakout cable has been designed with separate access to the individual wires to allow probing with current clamps. As an example this allows both injector current and injector voltage to be captured.
Note: the test lead is required to convert the 4 mm banana plug connection on the TA012 to a BNC connector suitable for plugging into the PicoScope.
