A3136, Active Oscilloscope Probe, 1,3 GHz
A3136, Active Oscilloscope Probe, 1,3 GHz
The Pico A3136 high-impedance active oscilloscope probe has minimal impact on the signal being probed with maximal signal transfer to the PicoScope 6000E Series. Its ergonomic design allows comfortable handheld use with a button to start and pause capturing in PicoScope 6.
The Intelligent Probe Interface (IPI) powers the probe from the scope and facilitates automatic probe detection and unit scaling. The probe can set scope attenuation and automatically switch to 50 Ohm input impedance.
With an input resistance of 1 MOhm and capacitance of 0.9 pF, this active probe offers high input impedance into the GHz range, up to 1.3 GHz.
These characteristics make this probe the most versatile for many of your day-to-day measurements.
Technical data:
Bandwidth | DC to 1.3GHz into 50 Ohm load DC to 1GHz (nominal) system bandwidth with PicoScope 6000E 1GHz oscilloscope |
Rise time | < 300ps |
DC gain accuracy | ±3% of full scale over +15 to +40°C, after 20-minute warmup |
DC offset accuracy |
±3mV over +15 to +40°C, after 20-minute warmup |
Input characteristics | 1MOhm || 0.9pF |
Attenuation | 10:1 |
Dynamic performance (typical) | |
Noise | 2.5mV (RMS) referred to probe input |
Pulse response | < 10% overshoot |
Bandwidth flatness | (+1dB, –3dB) from DC to full bandwidth |
Low-frequency flatness | < ±3% (or ±0.3dB) from DC to 250MHz |
Propagation delay | 5.4ns |
Input voltage | |
Full scale | ±5V (DC + AC peak) |
Absolute max. voltage | ±30V (DC + AC peak) subject to frequency derating |
DC offset range | ±10V |
DC offset control accuracy | ±1% of offset setting, additional to DC accuracy above |
General | |
Probe detection | Automatic with any oscilloscope with Pico Intelligent Probe Interface (IPI) |
Operating temperature range | 0 to +50°C For quoted accuracy:15 to 40°C after 20-minute warmup. |
Storage temperature range | -20 to +60°C. |
Operating humidity range | 5% to 80% RH non-condensing |
Storage humidity range | 5% to 95% RH non-condensing |
Altitude range | Up to 2000m |
Pollution degree | EN 61010 degree 2 : “only nonconductive pollution occurs except that occasionally a temporary conductivity caused by condensation is expected” |
Dimensions (probe body) | 108mm (L) x 16mm (H) x 12mm (W) |
Cable length | 1.2m |
Safety compliance | EN 61010-031:2015 |
EMC compliance | Tested to EN61326-1:2013 and FCC Part 15 Subpart B |
Environmental approvals | RoHS, WEEE, REACH |